New motor

[metalmonster90]

Just put a new two stroke on my bicycle. Starts up just fine runs good no high idle nothing. However there is a little bit of oil leaking from the spark plug and only from the spark plug i have the oil fuel mixture at 16:1 because it is a new motor however it will run for about 100ft and stall out any ideas what this could be?

 

[metalmonster90]

My engine had a stock short manifold, but I swapped it for the c&c just because it's pretty. It seems to flow a little bit better, I should have pulled the jug and port matched, but I didn't

I have never actually seen a c&c manifold idk if i could get that where i live either

 

[GW's Motorized]

I have never actually seen a c&c manifold idk if i could get that where i live either

Here is what it looks like, and comparison to the stock manifold

 

[metalmonster90]

Here is what it looks like, and comparison to the stock manifold

Oh yeah that does look awesome but i am sure it would not fit on my motor unfortunately its a pretty tight fit

 

[GW's Motorized]

Oh yeah that does look awesome but i am sure it would not fit on my motor unfortunately its a pretty tight fit

The stock manifold from my engine is a great deal shorter. The reason I went with the cdh manifold is the looks, and it has a built in O ring. I used an o ring on this end of the manifold as well as the built in one to get the best seal I can.

 

[metalmonster90]

The stock manifold from my engine is a great deal shorter. The reason I went with the cdh manifold is the looks, and it has a built in O ring. I used an o ring on this end of the manifold as well as the built in one to get the best seal I can.

Hmmm i may have to look into that because honestly the more seal the better

 

[GW's Motorized]

Hmmm i may have to look into that because honestly the more seal the better

This is the one I ordered

Amazon.com

 

[metalmonster90]

This is the one I ordered

Amazon.com

Yeah i will have to check it out but i am not sure if they will ship it to poland may not be cost effective

 

[GW's Motorized]

Yeah i will have to check it out but i am not sure if they will ship it to poland may not be cost effective

You could use a Drexel to do this to your own manifold. You'd just have to be careful not to go too deep

 

[metalmonster90]

You could use a Drexel to do this to your own manifold. You'd just have to be careful not to go too deep

Yeah i suppose i could but the metal is kind of thin unfortunately