Just bought a gx50 clone

[Chainlube]

Fill cap /dipstick has an O ring

Drain plug can be fiber or rubber, but the rubber ones can leak if torqued down too hard.

 

[darwin]

Did you over fill it? Bottom of the threads on a level surface is the full mark.

 

[Will'smotobikes19]

It is a o ring but it squishes almost flat maybe it's faulty either way it leaks

 

[darwin]

Is the Oring damaged? If it's contacting 2 surfaces all the way around it should seal. Is this motor just sitting there leaking? What position is the motor in? These are 360deg oriented motors and shouldn't leak in any orientation.

 

[Will'smotobikes19]

Just upright it leaks but the oil level is still up to the top of the fill I think you tip them to the side when you fill with oil

 

[darwin]

Use a funnel, they only hold 4oz or so.

 

[Will'smotobikes19]

I think this is what it needs looked up the part and it looks different from the plain o ring on the motor. https://www.ebay.com/itm/1855050934...Jy1OAWTwsSCJ3boTDyTH76t08R|tkp:Bk9SR_iF2_6tYw

 

[Will'smotobikes19]

Just got the seal which side is up/down the side with the number on it or the plain side? It has 2 raised rings on both sides.

 

[Will'smotobikes19]

Here's the part

 

[Will'smotobikes19]

Put the part on the dipstick but it has side to side play maybe the clone dipstick is smaller at the base? It has like 1/8 of side to side play