So a while back when I got my New Engine I got a few extras one of them was an expansion chamber exhaust. It is much better in-terms of performance and quietness but the biggest problem is who ever welded the flange really messed up big time. This thing is slanted really badly and the sad part is I really like this pipe.
One other thing that really annoyed me is I had to re-drill the holes they where way to small and then I had to hand grind and sand off the paint off of the flange to make it sit better.
I am thinking I could cut it off and re-weld it right if I only had a welder. If anyone has any ideas I'd be open to trying them.
For now I've just used some Permatex high-temp copper gasket marker because the gaskets keep falling apart and they don't sit right anyways.
Here is a link to the muffler for reference: http://www.amazon.com/Performance-Speed-Demon-Muffler-Expansion-Motorize/dp/B00L2PSAKY
One other thing that really annoyed me is I had to re-drill the holes they where way to small and then I had to hand grind and sand off the paint off of the flange to make it sit better.
I am thinking I could cut it off and re-weld it right if I only had a welder. If anyone has any ideas I'd be open to trying them.
For now I've just used some Permatex high-temp copper gasket marker because the gaskets keep falling apart and they don't sit right anyways.
Here is a link to the muffler for reference: http://www.amazon.com/Performance-Speed-Demon-Muffler-Expansion-Motorize/dp/B00L2PSAKY
Links to Amazon may include affiliate code. If you click on an Amazon link and make a purchase, this forum may earn a small commission.