P
Patch
Guest
So I fixed my engine after maybe 2-3 weeks after a stripped head stud So once reassembled...the engine will not fire. I got a new plug and I checked the spark quality... and when i touch it its moderatly painful goin 6mph
So I tried starting it again and still nothing, so I pulled the plug and it is wet...but is it too wet?
So Im prettyt sure its getting fuel and I have redone the carb in the process. I am also quite sure is getting spark but is it too little spark I don't know what to do now I will go check the magneto due to a post I found in the search he said the magnet wasn't tight so it wasn't spinning... but I doubt thats it So while I go check my magneto...can someone tell me whats wrong? Is there anyway to check my CDI?
EDIT:::: I found out that my CDI wires were set backwards...dumb mistake that im sure will never happen again I realized this when I would get jerked backwards when the engine actualy tried to start...time for a midnight run
Thanks amigos
So I tried starting it again and still nothing, so I pulled the plug and it is wet...but is it too wet?
So Im prettyt sure its getting fuel and I have redone the carb in the process. I am also quite sure is getting spark but is it too little spark I don't know what to do now I will go check the magneto due to a post I found in the search he said the magnet wasn't tight so it wasn't spinning... but I doubt thats it So while I go check my magneto...can someone tell me whats wrong? Is there anyway to check my CDI?
EDIT:::: I found out that my CDI wires were set backwards...dumb mistake that im sure will never happen again I realized this when I would get jerked backwards when the engine actualy tried to start...time for a midnight run
Thanks amigos
Last edited by a moderator: