Ok, so I see everyone building their bike I figured I'd start my own build thread in hopes that I can get some good feedback and if anything ideas on where to go with everything. Here is a pic of the jig I setup and the bike sitting in roughly the place it will stand once done. This is a one off build and will be built with chromoly tubing, a pit bike engine, and a jackshaft assembly similar to what I have seen on the motopeds.com build and sickbikeparts jackshaft setup. What I have on order that should be here in a few days: exhaust, handle bars, sprockets for wheel and jack shaft, and disk brakes. What I have now: head tube, wheels and tires, engine, seat, track ends, throttle, carb, (air filter on order). What was custom made: the rear hub which is a dual disk rear from Phil Woods..This will give me disk brakes and bolt holes for the sprocket on either side of the hub. Tires are Hookworms and Halo SAS rims with a Halo Spin doctor from hub...using a Manitou Circus front fork(really stout little fork for the price)..Using a Cane Creek headset and the head tube is a 44mm 4130 tube from paragon machine works. Whats needed: tubing(measurments for tubing), 3/4" shaft for sprockets to ride on, a custom made bottom bracket or I might decide to go with SBP wide bottom bracket setup but not sure if will be wide enough for what I need(if anyone has exact measurements of how wide it is after pedals installed that would be awesome)
Now let me know your feedback..PLEASE!!
Now let me know your feedback..PLEASE!!