Apologies in advance if I am violating or duplicating. I have spent time searching the forums and can't find what I need.
Today I finished the install of my Grubee 80/66 cc with the high performance carb. The test drive was atrocious. Skipping, sputtering, and dying out. Muffler was smoking when I got back after 10 minute ride.
The carb is not like the one I had on old motor. There is no primer to press and I see no choke to pull up or push down. There is an extra cable (besides the throttle) coming from carb to handlebar. I am assuming this to be choke?? The instructions coming with these kits leave a lot to be desired. I did read one very detailed post concerning working with carbs and adjusting lean/rich position of the "pac-man" washer. But don't want to make matters worse if that's not it. Total green at mechanics. You think I should get into that, or does it sound like something else.
The throttle came already attached to the carb and the [choke?]. I did reset the screw on the carb backing off 3 1/2 turns as the instructions said. Didn't seem to help.
Brand new motor. SHouldn't be this much trouble. any help would be appreciated.
Today I finished the install of my Grubee 80/66 cc with the high performance carb. The test drive was atrocious. Skipping, sputtering, and dying out. Muffler was smoking when I got back after 10 minute ride.
The carb is not like the one I had on old motor. There is no primer to press and I see no choke to pull up or push down. There is an extra cable (besides the throttle) coming from carb to handlebar. I am assuming this to be choke?? The instructions coming with these kits leave a lot to be desired. I did read one very detailed post concerning working with carbs and adjusting lean/rich position of the "pac-man" washer. But don't want to make matters worse if that's not it. Total green at mechanics. You think I should get into that, or does it sound like something else.
The throttle came already attached to the carb and the [choke?]. I did reset the screw on the carb backing off 3 1/2 turns as the instructions said. Didn't seem to help.
Brand new motor. SHouldn't be this much trouble. any help would be appreciated.