flossandfly
New Member
- Local time
- 1:27 PM
- Joined
- Jan 2, 2012
- Messages
- 8
I bought the friction drive Robin Subaru 035 kit from Stauton inc and recently got to try it out. I get lots of rattle noise until I speed up the engine, it sounds like the same problem as the guy in the thread below.
http://www.motoredbikes.com/showthread.php?t=13731&highlight=clutch+rattle
The thread above advised adjusting the idle slower so that the clutch would not rattle. I read the owners manual and it said "The carburetor greatly affects the
performance of the engine.
Since it has been adjusted carefully
at our factory before shipment, avoid
adjusting unless absolutely necessary.
If adjustments are needed, contact
your nearest dealer."
So I would like advice from the veterans here. I am kind of disappointed since I bought what appeared to be a top notch kit from a top notch company.
http://www.motoredbikes.com/showthread.php?t=13731&highlight=clutch+rattle
The thread above advised adjusting the idle slower so that the clutch would not rattle. I read the owners manual and it said "The carburetor greatly affects the
performance of the engine.
Since it has been adjusted carefully
at our factory before shipment, avoid
adjusting unless absolutely necessary.
If adjustments are needed, contact
your nearest dealer."
So I would like advice from the veterans here. I am kind of disappointed since I bought what appeared to be a top notch kit from a top notch company.