dchevygod
Member
- Local time
- 6:15 AM
- Joined
- Mar 7, 2011
- Messages
- 473
i posted this to gopednation so i could find some lathe work
I need a custom spindle for a 460 clutch housing and a third bearing. Im lacking a micrometer but i need 1.25" diameter with a hole in one end just wide enough to fit on the stock 460 clutchhousing its just shy of 15mm but only 7/8" deep, and one end needs to be lathed down for a third bearing to fit i think its 5/8" the bearing is a 6202rs,
Ok so it should be L=3-5/8" , dia=1-1/4" , 0ne end largened to fit tight on to cy clutch housing 7/8" deep with a threaded setscrew hole, the other lathed to fit inside a bearing with an inside diameter of 5/8", im putting a 460 on a friction drive bike kit and this is the last part i need to get it mounted on the bike and get a 460. Any help would be appreciated guys thanks in advance.
This was a kit i bought and it was junk so i redesigned it using the cy housing whitch fixed the main problems with this design but i need the custom spindle. Dang i wish i had a lathe!
this is before i did any modding.
This is after i made the bearing hole large enough for the housing to slide in and be tru.
this is yesterday i got the 1" nylon spacers and am ready to mount the engine but its not going anywhere without a spindle!
This is the old 7/8" spindle " i need one bearing removed and that end fitted on the shaft secured with a setscrew" though i want a 1.25 modding this one will help with designing the new one i think.
I need a custom spindle for a 460 clutch housing and a third bearing. Im lacking a micrometer but i need 1.25" diameter with a hole in one end just wide enough to fit on the stock 460 clutchhousing its just shy of 15mm but only 7/8" deep, and one end needs to be lathed down for a third bearing to fit i think its 5/8" the bearing is a 6202rs,
Ok so it should be L=3-5/8" , dia=1-1/4" , 0ne end largened to fit tight on to cy clutch housing 7/8" deep with a threaded setscrew hole, the other lathed to fit inside a bearing with an inside diameter of 5/8", im putting a 460 on a friction drive bike kit and this is the last part i need to get it mounted on the bike and get a 460. Any help would be appreciated guys thanks in advance.
This was a kit i bought and it was junk so i redesigned it using the cy housing whitch fixed the main problems with this design but i need the custom spindle. Dang i wish i had a lathe!