LunchMoney
New Member
Okay, so, motorized bike, only idles while on choke = air leak, right? Now, do I just start spraying every hole and every crevace of the bike with wd 40 to check for leaks?
Engine Trouble Where is it
- Thread starter LunchMoney
- Start date
Never hurts to go over the motor first. Make.aure to check the head.nuts are tight as they work loose over time, especially when the engine is new. Check the intake bolts are tight and the carb is seated properly to the intake and tight. That will often take care of a lot of the most common causes.
After that, then yes, start checking for leaks, but don't just spray willy-nilly. Focus on areas and observe for changes
LunchMoney
New Member
Okay, finally located the leak where the carb meets the intake, it's weird, cause it is tight there. Should I put on some gasket sealant on there?
GW's Motorized
Well-Known Member
Is there atill an O ring between the carb and intake
LunchMoney
New Member
No, it's the delorto clone, it only has a plastic tube inside the carburator. I don't think that it is possible to fit an o ring there
GW's Motorized
Well-Known Member
It goea at the very end, not between the tubes
