Mini Bike seat. 10" x (5.5" front width, 7" rear width) x (3" front height, 5.5" rear height) I'm going to cut a hole in the bottom panel of this seat and bury the post in it so the seat is slammed all the way down. (Mongoose Dolomite build in progress.)
I am designing a motor limo bicycle 49cc
I was thinking adding 2 exhaust together first the expansion tube exhaust in the front then piped down to a poo poo long pipe muffler going down the side.
Was wondering would doing that hurt any performance or anything
Hey I'm new to motorized bikes (my first engine is still shipping), and I was wondering, what are some good performance mods to do on a cheaper budget, and in what order? I was thinking to do:
-Exhaust
-CDI
-High compression head
-36 tooth rear sprocket
-?
I ordered a new bullet train 80cc motors and I was wondering is it safe to use performance parts on it like a sbp expansion chamber and other things like reed valves and a speed carb.
Josh89
Thread
break in
expansion chamber
mods
motorized bike
new motor
performance
reed valve
Going to post some pictures of the work I did eventually when I have time but I follow Jaguars site and put some holes in my piston (12 specifically) and bored out my wrist pin a little bit (calipers useful) (plus cleaned out flash/ lil bit of porting). I would have done more but feared for the...