How to get piston back into cylinder?

Status
Not open for further replies.
See, EGOR? That's what an administrationalist is for! Tells us how to ringalize one of these itty-bitty engines and with pictures too!:D
 
ok, guys....we already discussed how-to put the piston in....and some places to buy rings & stuff.

feel free to take the "2 ring vs. 1 ring" debate to General Discussion & start a thread.

Just remember to play nice. :cool:
 
Last edited:
Take a can (big enough to go around the rings) cut the top and bottom out, make a slit up the side, rebend it backwards around your ring/rings then take a piece of twine and tie it in a loop bigger than the can then take a rod or stick and twist the twine to tighten the can to tighten the rings that fall into the place that Jack built. Har Har!
This does work great for ring replacement.
 
Status
Not open for further replies.
Back
Top