cuz1961
New Member
hello gents,,
new to the board,,, this place looks like home !
have a staton friction drive kit with subaru robin 035A.
love this combo. it still starts on first pull at 3500 miles !
but it is time for me to replace the clutch pads.
bought the pads and a clutch drum. there is slight scoring on
the very inside 1/8 inch of the surface,
? should i replace it with the new clutch drum ?
or should i wait to replace the drum on the next pad change ?
my BIGGEST question,,, and why i have come here to what looks
like a board full of friction drive guru's and masters /-),
!!! HOW do i get the clutch pad bolts off ?
every time i try and turn the bolt the whole assembly turns.
( im afraid to use penetrating oil to help the bolts come unstuck
cuz oil in a friction clutch housing is probably not a good idea ? )
( im afraid of trying to stick a leverage bar against the housing
to hold the pads from spinning for fear of cracking or breaking
any of the parts )
( am i really going to have to pull the recoil pull starter assembley
to get to the other side of the crank, to hold the crank from spinning
to get opposing leverage to crack loose the clutch pad bolts ?)
this is my only transportation and its sitting here in my living room
mocking me cuz i dont know how to get these clutch pad bolts off !
MOCKING me i tell ya ! /-)
any suggestions would be greatly appreciated.
thank you
cuz1961
new to the board,,, this place looks like home !
have a staton friction drive kit with subaru robin 035A.
love this combo. it still starts on first pull at 3500 miles !
but it is time for me to replace the clutch pads.
bought the pads and a clutch drum. there is slight scoring on
the very inside 1/8 inch of the surface,
? should i replace it with the new clutch drum ?
or should i wait to replace the drum on the next pad change ?
my BIGGEST question,,, and why i have come here to what looks
like a board full of friction drive guru's and masters /-),
!!! HOW do i get the clutch pad bolts off ?
every time i try and turn the bolt the whole assembly turns.
( im afraid to use penetrating oil to help the bolts come unstuck
cuz oil in a friction clutch housing is probably not a good idea ? )
( im afraid of trying to stick a leverage bar against the housing
to hold the pads from spinning for fear of cracking or breaking
any of the parts )
( am i really going to have to pull the recoil pull starter assembley
to get to the other side of the crank, to hold the crank from spinning
to get opposing leverage to crack loose the clutch pad bolts ?)
this is my only transportation and its sitting here in my living room
mocking me cuz i dont know how to get these clutch pad bolts off !
MOCKING me i tell ya ! /-)
any suggestions would be greatly appreciated.
thank you
cuz1961
Last edited: