Hybricycle
New Member
- Local time
- 3:30 PM
- Joined
- Jan 23, 2014
- Messages
- 6
Hello Motorbikes community! I recently swapped the insides of a running motor & head assembly with stripped/damaged mounting holes onto a lower 2pc lower good case with good mounting holes, basically swapped the lower 2pc cases, and installed all new gaskets.Now the motor won't start, magnito reads with in spec.- spark plug has spark, after many attempts I checked the plug-dry,removed the top of the head & its completely dry inside, doesnt seem to be drawing/sucking fuel into the motor, with air filter off & attempting to start it spits a little fuel out the filter side.And I've tried two different carbs also.Any ideas Motorbike community, what did I doo wrong?Best Regards.