I just recently put a kit on my bicycle and im really enjoying it as its my first.
At the moment it has about 50 miles on it and has been four stroking for about 25 miles. I am using a good oil, started at a 16-1 mix and it was going fine until it started four stroking. so what i have tried is...
I added an inline filter
i leaned out the mix and tried, then added more oil and tried again
i have changed plug NGK B6HS
tried different setting's on the slide needle
taken the air filter off for a test
turned off fuel flow
and changed the idle screw setting
the bike is running okay under acceleration and load until it reaches a steady pace then begins for stroking also seems to have a lower top speed and kind of bogs down at WOT.
checked the plug after a few 20-30 min rides and it was black and wet. i want to lean out the mix but 24-1 left the plug kinda white.
engine is an unknown brand 48cc slant head.
air temperature for most rides has been around 4-10 degrees celcius and altitude is around sea level but 50 miles from the coast.
bike never needed choke to start, choke would only smother it.
So with all that said can anyone help me?????
do i have a problem or is this just a break in problem that will go away????
only thing i haven't tried is a smaller main fet in the carb (NT carb), tempted to put some fine wire in it just to test tomorrow.
Please guy's all help will be very much appreciated
At the moment it has about 50 miles on it and has been four stroking for about 25 miles. I am using a good oil, started at a 16-1 mix and it was going fine until it started four stroking. so what i have tried is...
I added an inline filter
i leaned out the mix and tried, then added more oil and tried again
i have changed plug NGK B6HS
tried different setting's on the slide needle
taken the air filter off for a test
turned off fuel flow
and changed the idle screw setting
the bike is running okay under acceleration and load until it reaches a steady pace then begins for stroking also seems to have a lower top speed and kind of bogs down at WOT.
checked the plug after a few 20-30 min rides and it was black and wet. i want to lean out the mix but 24-1 left the plug kinda white.
engine is an unknown brand 48cc slant head.
air temperature for most rides has been around 4-10 degrees celcius and altitude is around sea level but 50 miles from the coast.
bike never needed choke to start, choke would only smother it.
So with all that said can anyone help me?????
do i have a problem or is this just a break in problem that will go away????
only thing i haven't tried is a smaller main fet in the carb (NT carb), tempted to put some fine wire in it just to test tomorrow.
Please guy's all help will be very much appreciated