woodlandSerenade
New Member
Hello everyone!
I've run into a little snag with my first build.
I'm using an old Tecumseh 3.5HP four-stroke that I stripped from a well-antiquated snowblower, and assuming I can weld straight, I can work with the clutch and everything related to the engine itself.
But now, my actual question.
Is there a jackshaft kit that I could modify, or even fabricate, to be able to use this hulking mass of engine with it mounted above my rear tire?
I've run into a little snag with my first build.
I'm using an old Tecumseh 3.5HP four-stroke that I stripped from a well-antiquated snowblower, and assuming I can weld straight, I can work with the clutch and everything related to the engine itself.
But now, my actual question.
Is there a jackshaft kit that I could modify, or even fabricate, to be able to use this hulking mass of engine with it mounted above my rear tire?