What I am doing is making a rear wheel out of a front wheel
1) Cut the hub off a junk rear wheel (1 that fits your sprocket)
2) on one side of the front wheel shaft remove the bearing and slide the hub over the shaft - but leave a little nub on the hub - ha
3) screw on your tapered bearing guide and a lock nut.
Thats the basics - you can drill through the hubs spoke holes into the sprocket - and just add screws to hold in place.
4)I used 2 rubber gaskets on the outside and 1 inner.
It got dark so will have to wait till tommorrow to finish tightening the bolts -
did a quick check for clearance on the bike - looks good so far..
1) Cut the hub off a junk rear wheel (1 that fits your sprocket)
2) on one side of the front wheel shaft remove the bearing and slide the hub over the shaft - but leave a little nub on the hub - ha
3) screw on your tapered bearing guide and a lock nut.
Thats the basics - you can drill through the hubs spoke holes into the sprocket - and just add screws to hold in place.
4)I used 2 rubber gaskets on the outside and 1 inner.
It got dark so will have to wait till tommorrow to finish tightening the bolts -
did a quick check for clearance on the bike - looks good so far..
Attachments
-
DSC00007.jpg55.2 KB · Views: 594
-
DSC00008.jpg76.7 KB · Views: 464
-
DSC00009.jpg69.6 KB · Views: 475
-
DSC00010.jpg71 KB · Views: 446
-
DSC00011.jpg48.2 KB · Views: 447
-
DSC00012.jpg64.2 KB · Views: 436
-
DSC00013.jpg64.9 KB · Views: 418
-
DSC00014.jpg71.3 KB · Views: 447
-
DSC00015.jpg70.3 KB · Views: 450
-
DSC00016.jpg70.6 KB · Views: 436
-
DSC00017.jpg73.8 KB · Views: 440
-
DSC00018.jpg58.2 KB · Views: 437
-
DSC00019.jpg53.2 KB · Views: 433
-
DSC00020.jpg51.8 KB · Views: 431
-
DSC00021.jpg59.7 KB · Views: 437
-
DSC00022.jpg47.2 KB · Views: 437
-
DSC00023.jpg65.7 KB · Views: 437
-
DSC00024.jpg51.7 KB · Views: 420
-
DSC00025.jpg56.2 KB · Views: 453
-
DSC00026.jpg65.5 KB · Views: 485