1st chopper build, wasted bike.

Well I got this thing from a kid in the local area for $10. cause I have wanted one since our first build. which suffered a snapped frame, while in use. I wasn't sure if it would clean up enough to look good but, after a few hours of hobbying, you can see where she is headed.

Only way I could figure to mount the motor requires a trip to a welder to have a few mounting pipes installed and then the rest shouldn't be too hard.

http://motoredbikes.com/album.php?albumid=774
 
your triple tree (forks) look to me to be on backwards. i would like to see the tire set forward not to the rear .
should be a fun prject , good luck and happy motor n
 
That be an OCC or a WestCoast Choppers chopper? One of my fav builds here on MB is BrettMavriks OCC custom chopper-->

attachment.php


Might give you some ideas anywayz

BEst of luck

KiM
 
oh and it is a west coast chopper.

Michael (sphynx.0029) my son and I are both doing a new bike project (last one cracked the frame in two. Yes the front end was installed incorrectly, I wonder if the kid that did it could ever figure out why it had NO turning radius. Having bars wielded tomorrow to mount the engine, I found a what I felt was a good deal on a Huffy Cruiser $20.00. It has a vintage working speedometer and a seat for my big azz (Wal Mart...I call them China Mart.. wants $24.00 for the seat alone)..and E-Bay has the speedometers for $15.00 and up. Bike is rough but workable without too much trouble.
 

Attachments

  • P9030152.jpg
    P9030152.jpg
    131.4 KB · Views: 2,183
  • P9030154.jpg
    P9030154.jpg
    153.8 KB · Views: 2,085
  • P9030155.jpg
    P9030155.jpg
    190 KB · Views: 2,145
  • P9030156.jpg
    P9030156.jpg
    209.8 KB · Views: 2,106
Last edited:
Back
Top