Lippa
New Member
Hello everyone,
Although I have read many posts on kill switch, I can't seem to find the same problem other people had. I called bicycle-engines.com for clarification but they never called me back, so here I am.
I have a new Honda GHX50 engine that has 3 wires coming off the engine:
1. a yellow wire with a male terminal (low oil sensor)
2&3. a black wire with a spin-off, both female ends
There is no toggle switch already on the engine.
Then the kit comes with a small "something" the size of a gaming die (die as in singular of dice) with 2 wires approximately 3in long, a yellow terminal female and a black terminal male. Is this part of this kit or should I not worry about it?
Then the kill switch from the throttle has two wires ending with as a male and a female.
How do I connect all these wires together????????
I'm not an electrical engineer, so I'm completely lost and any help to this newbie would be appreciated.
Thank you
Although I have read many posts on kill switch, I can't seem to find the same problem other people had. I called bicycle-engines.com for clarification but they never called me back, so here I am.
I have a new Honda GHX50 engine that has 3 wires coming off the engine:
1. a yellow wire with a male terminal (low oil sensor)
2&3. a black wire with a spin-off, both female ends
There is no toggle switch already on the engine.
Then the kit comes with a small "something" the size of a gaming die (die as in singular of dice) with 2 wires approximately 3in long, a yellow terminal female and a black terminal male. Is this part of this kit or should I not worry about it?
Then the kill switch from the throttle has two wires ending with as a male and a female.
How do I connect all these wires together????????
I'm not an electrical engineer, so I'm completely lost and any help to this newbie would be appreciated.
Thank you
Last edited by a moderator: