PabstBlueRibbonrulz!
New Member
Hello,
I am attaching the sprocket, rubber donut assembly to my rear wheel and found that the plates which bolts finally go through overlap each other. (Three semi-circular plates (9 holes each))
My problem was described here: http://www.motoredbikes.com/showthread.php?t=19557 but no one gave a solution.
This looks exactly the same as what I am describing:
http://www.motoredbikes.co/attachment.php?attachmentid=17181&d=1240205107
I've really wrestled it, but I just wont align. If all else falls could I bust out the ol' hacksaw and trim the plates??
I am attaching the sprocket, rubber donut assembly to my rear wheel and found that the plates which bolts finally go through overlap each other. (Three semi-circular plates (9 holes each))
My problem was described here: http://www.motoredbikes.com/showthread.php?t=19557 but no one gave a solution.
This looks exactly the same as what I am describing:
http://www.motoredbikes.co/attachment.php?attachmentid=17181&d=1240205107
I've really wrestled it, but I just wont align. If all else falls could I bust out the ol' hacksaw and trim the plates??