M mrbg Member Local time 5:20 PM Joined Sep 22, 2014 Messages 241 Sep 29, 2014 #21 I'm at 100'ft asl so #64 would probably be ok? Also 2nd notch from top of needle rite. Thanks again
G gator joe Member Local time 7:20 PM Joined Oct 16, 2014 Messages 48 Location Miami Oct 16, 2014 #22 mrbg said: Was the acetone used as a Admix to fuel? Click to expand... Dont put acetone in that motor are you crazy. Just adjust your carburetor andclip correctly
mrbg said: Was the acetone used as a Admix to fuel? Click to expand... Dont put acetone in that motor are you crazy. Just adjust your carburetor andclip correctly
B Breeeze Guest Nov 27, 2017 #23 I found a solution to bogging while researching the Keihin carbs. Ok, so take the needle, and take a dremel with small sanding tool... Very, very gently sand down the tip to a more transitioned shape.. So you want the taper to be longer and more gradual.. This will allow a better transition in flow, giving a pretty good WOT pull.. Hope this is helpful
I found a solution to bogging while researching the Keihin carbs. Ok, so take the needle, and take a dremel with small sanding tool... Very, very gently sand down the tip to a more transitioned shape.. So you want the taper to be longer and more gradual.. This will allow a better transition in flow, giving a pretty good WOT pull.. Hope this is helpful
K Kpi890 Active Member Local time 7:20 PM Joined Nov 6, 2017 Messages 346 Nov 28, 2017 #24 Following!