HT final gear ratio?

QuadManiac

Member
Local time
11:17 AM
Joined
Aug 17, 2008
Messages
76
Location
San Diego, CA
I've tried searching to no avail. Is anybody able to provide me with the final output gear ratio for the standard HT 2 stroke (just to the output shaft, not including the sprockets and chain)? OR the # of teeth on the crankshaft gear and on the output shaft gear (under the clutch)?

Thanks.
 
Last edited:
Thanks for the help but that post only says "these chinese bike engines have an internal gear reduction....roughly 4:1". I'm hoping to find a little higher resolution answer than that.
 
From memory it was 4:1 to 1
and even though all these chinese motors look similar there
are differences so they could vary a little bit
 
Back
Top