Drunkskunk
Member
- Local time
- 5:17 PM
- Joined
- Feb 18, 2008
- Messages
- 124
No, nothing to do with the Atkins diet. Just the lump of metal on the side of the engine. Anyone have a link to tuning the Happytime Carbs? I tried putting mine on a working motor last night to set it up, but it won't run it, and i can't figure out how to tune the thing, or diagnose what it's doing wrong when it does sputter.
If it helps, the symoptoms are,
it won't start cold.
it won't start hot.
it will start warm. (touchable, but painfull for long)
It doesn't matter if the choke is on or off, or any combo in between.
it idles at near full throttle, turning the screw in the side instantly kills it, turned in either direction
touching the throttle kills it.
Its a known working motor. the working carb is diffrent, but the same size and mounting configuration.
I'm not even sure what the screw in the side does. is it idle speed? idle mixture? true mixture? If its for idle speed, Does it go in, or out for faster? If it's mixture, is out richer?
The instructions with the bike are in engrish, and it only says that "Adjusting the curb is being by screw" :???:
If it helps, the symoptoms are,
it won't start cold.
it won't start hot.
it will start warm. (touchable, but painfull for long)
It doesn't matter if the choke is on or off, or any combo in between.
it idles at near full throttle, turning the screw in the side instantly kills it, turned in either direction
touching the throttle kills it.
Its a known working motor. the working carb is diffrent, but the same size and mounting configuration.
I'm not even sure what the screw in the side does. is it idle speed? idle mixture? true mixture? If its for idle speed, Does it go in, or out for faster? If it's mixture, is out richer?
The instructions with the bike are in engrish, and it only says that "Adjusting the curb is being by screw" :???: