Latest activity
-
Wtg78 replied to the thread Now it's the engine in general.I'm pretty sure I put a new spark, magneto, and cdi on it but is there a way to check or on my own without special tools of any kind -
Wtg78 replied to the thread Now it's the engine in general.I have done all of these things except the torque of the head bolts but I'm pretty sure that's not it I've taken the carb and Reed valve...
-
WWhitewill1412 replied to the thread Another new toy.It will not be welded to the vise and it will be mounted to wood and the leg will be straight to the ground
-
WYup, bolt on vise
-
WI think it was my Dad's Dad's. Funny, I gave it to a guy because he didn't have much and thought he would use it. Turns out a few...
-
WThe concussion pounding force goes thru the leg to the floor The mount is adjustable for table height The vise is held in place to the...
-
I would say at least 300 to 500 miles of break-in would be a reasonable figure, so your 5 4L tanks is pretty much on point. -
You and me both. Nice part of the state. It hasn't been so long ago I was in Knoxville to see a concert. -
That's around a 190 miles from me. You'd go right by my little town Rockwood, if you ever go to Knoxville or Dollywood etc. I'd love to... -
Sidewinder Jerry reacted to zean's post in the thread After each ride rear wheel gets tight. with
Like.
Maybe the tip of the set screw that goes through the clutch plate is touching the clutch gear. -
Ghost racer 50cc is a 4 stroke HS 49cc Stock clutch is probably engaging at 1,500 RPMs Change the clutch springs to 2,000 RPM springs...
-
If the clutch lever is pulled all the way in and it is still turning the rear wheel, then you do not have the clutch assembly adjusted...
-
Zzean replied to the thread After each ride rear wheel gets tight..Maybe the tip of the set screw that goes through the clutch plate is touching the clutch gear.