Activity Stream

okay yes and I assumed this, but it won't fit on at all... I've used a vice and nothing gets it on. took apart assembly and the piece looks like it...

Be warned that the chain drive pocket bike gearbox in the kit you link to is junk and not very reliable. That is why the dishonest sellers hide...

I just installed a Hua Sheng on a customer build. Installed a pulse fuel pump, which works fine, but I popped the valve cover off to install a pump...

OP theres a dax f/d kit for sale in the for sale section. Owner said he'd consider selling it separate from the motor. Might get a good deal on it....

That HS motor will outlast your interest this hobby maybe, those are great quality motors. Its the rest of the kit you might have problems with...

That's the way these caps are designed, the idea is the cap will grip the plug better and take more vibration. You always have them on off road...

yeah, looking it up I see there is a S6-E ELECTRONIC Morini engine for $500 that outputs 3.2hp at 6000 rpm. It is out of stock though. That would be...

a friend just came over so I used her phone camera to take some shots. I will put them on my site. They don't show the finished product though, just...

I personally use Staton Inc. You'll have to get rid of that fixie hub or have a freewheel in your peddle crank. KC Kruiser's is located in your...

If you have a picture of the freewheel hub (freehub), it is a possibility that it could be identified. Unfortunately, the freehub has to match the...

No Honda or Soobies. The only f/d kit I have is the 40cc Robin and ThatsDAx listed here. I might split the kit up and sell the ThatsDax friction kit...

It's a bit more complex than that, in fact mind numbingly complex. I have spent hundreds of hours over the last couple of years just to see how hard...

Thanks Anton, for adding Races to the Races, Events & Group Rides Forum Two Year Anniversary SoCal Motor Bicycle Racing June 1, 2013 at Grange...

There is a 3 horsepower specification for a Morini engine which i would have assumed to be ported for lower rpm performance, but if what you say is...

A rear rack can sometimes disrupt the lines of your bike, but jbcruisin is right. You have a great rack.

I like the eliomotors vehicle. It offers better weather protection than Scooter-based trikes.

The Morini is well made but it unfortunately is ported for high rpm power, not for a broad powerband. That would require lathing probably 2mm from...

Welcome to the forum. It would be great to just buy a nice Royal Enfield, wouldn't it? They are beyond my budget too these days. The Chinese HT 2...

From that perspective :iagree:

O'yes Fabian, I agree with you 1000%...............................The thing about it is, if I went with Morini, I would go back into the flew blow...

Shouldn't take you any more than 3 minutes to remove a piston from an intact Chinese bicycle engine. Assembly would take around 10 minutes (with a...

and to think that all of this work is already done in a Morini engine, and if you are using a single speed drive method, it's just a simple case of...

Anyone up for a timed contest of removing a Grubee engine? How long does it take you to remove the piston from a fully intact setup?

So, HS you would raise/widen exhaust port inside jug? See, I just don't want to kill my lows and mids? Wonder how much I need to remove from exhaust...